User's Manual
Table Of Contents
- Table of Contents
- Product Registration Information
- Safety Guidelines
- Acronyms and Defi nitions
- Functional Overview
- Electrical Characteristics
- Mechanical Specifi cations
- AC Power Specifi cations
- Environmental Requirements
- Mechanical Drawing
- System Set-Up Considerations
- Wall Mounting
- Rack Mounting
- Optional Accessories
- Important Installation Notes
- Powering Up the Unit
- Local Communication Interface Ports
- USB Interface
- Ethernet
- Monitoring & Alarms
- Web based GUI Session
- User Maskable Alarms
- GPS Alarm
- Software Abort Alarm
- Software Error Alarm
- Property Failure Alarm
- Phase Lock Alarm
- FPGA Programming Alarm
- Hardware Control Alarm
- Text Menu Interface (Local Access)
- Telnet Session (Remote Access)
- Additional Tips
- Warranty
- Index
-12-
Primary access to the unit is gained using a LAN connection and a web browser program such as Firefox by Mozilla, or Internet Ex-
plorer from Microsoft. The beacon ships with the default IP address of 192.168.1.100, but it can be changed later if required.
If connecting directly to the unit from a laptop or PC with a crossover CAT-5E cable or over a LAN the user types the IP address of
the unit into the browser address line to connect.
(Note: Most users will need to update the TCP/IP settings on their computer to enable
connection to a host that has a static IP. Select “Use the following IP Address” and enter the IP Address as follows: 192.168.1.x, where
“x” = any number from 2 to 254 inclusive other than 100. The subnet mask is 255.255.255.0. Questions pertaining to these settings
should be referred to the user’s IT department or you may refer to the Additional Tips section at the end of this manual.)
When con-
nection is made the user will be prompted for a user name and password. For the purpose of the GUI session, the default user name is
webuser and the password is csi1234. This can also be changed as required. Internet access is not required to use the GUI.
(Note: If
you are connecting using a laptop, verify that your Ethernet port is powered. Some laptops will not allow Ethernet connection when on
battery power. If this is the case with the laptop you are using you will need to plug it in or update the power settings.)
Web based GUI Session