User Manual

Installation and Operator Handbook Programming and Configuration
AMX-MA-00657 Issue: 1.02 (USA) Page 9
5.4 Programming The Radio
5.4.1 Radio Wide Settings
The Radio Wide Settings dialog box is accessed via Program | Radio Wide Settings. This dialog box
contains general DMR-25 Transceiver parameters as shown in Figure 5-4.
• IP address and netmask parameters for the ethernet interface (future option).
• Front panel audio enable and volume adjustment.
NOTE
This parameter adjusts the audio levels sent to the transceiver front panel RJ45 connector.
Settings made here will have no effect on audio sent to any front panel speaker that is an
integrated part of any DMR radio.
Figure 5-4 Radio Wide Settings Dialog Box
The radio wide settings of the currently open file will be displayed.
To enter IP Configuration parameters: (Future Option)
This function is not currently available but will be included in future releases of the radio software
package.
1. The IP configuration is required whenever the DMR is connected to a LAN using the ethernet facility
on the Interface Module.
2. Point the cursor to a cell where the change is required, click and enter the new parameter. The cursor in
the cell will flash when selected. The cells can be highlighted in sequence using the <Tab> key.
To enter Front Panel Audio parameters:
1. Audio On or Off. Point and click as required to enable or disable audio output to the DMR-25 front
panel audio connector.
2. Audio Level. Click the up or down buttons to select an audio volume level from 0 to 10.(maximum)