User Manual

Installation and Operator Handbook DRB-25 Diagnostics Monitor
AMX-MA-00656 Issue 0.02 (USA) 11
Figure 6-7 Test Radio Dialog Box
Appl y
The Apply button sets the Enable Local PTT, Enable Intercom and Channel. This is, however, not stored on
the Transceiver Module.
Tx On
The TDM Test dialog box Tx On button selection causes the TDM to write the factory test parameter to the
selected Transceiver Module. The transmitter is turned on using the selected test tone as the modulation
source. Note that if TDM is closed with TX On still selected then TDM will turn the transmitter off before
closing and the transceiver will revert to its normal operating mode for its current channel.
Tx Off
Turns the transmitter off.
OK
Closes the Test dialog box returns the user to the Main dialog box. The transmitter is returned to the off
state and the Enable Local PTT and Enable Intercom revert to their previous settings.
If a channel has been changed during a test session then a box will appear after the user closes the test dialog
box : ‘The current channel of Radio x has been changed during this session. Do you wish to change the radio
back to its original channel?’ Yes/No. If yes is clicked, then the channel will be changed back to the channel
in use when the TDM session was started.
Cancel
Closes the Test dialog box without writing data to the .INI file..
Help
Provides access to on-line help on the Polling Interval dialog box.