Installation Guide

ManualsBrandsWestek ManualsCabinet LightsLED Cob Task Under Cabinet Bar Light (2-Pack)

Warning

To reduce the risk of electrical shock, do not put the unit in water or other liquid. To clean, use a soft dry cloth.

Do not place or store bar light where it can fall or be pulled into a tub or sink.

Battery Precautions

1. Use only the size and type of batteries specied.

2. Always purchase the correct size and grade of battery most suitable for the intended use.

3. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment.

4. Do not mix alkaline, standard (Carbon-Zinc), or or rechargeable (Nickel Cadmium) betteries.

5. Replace all batteries of a set at the same time. Do not mix old and new batteries.

6. Clean the battery contacts and also those of the device prior to battery installation.

7. Do not dispose of batteries in re.

8. Remove batteries if consumed or if product is to be unused for an extended period of time.

9. Follow instructions for recycling for the batteries you use. (Lithium-ion batteries must be disposed of at a household hazard-

ous waste collection point (check with your local landll) or battery recycling drop off location, NOT placed in the trash.)

Limited Warranty

Under normal use and conditions, AmerTac provides to the original purchaser of this product a one year express warranty that

is set forth in the Limited Warranty stated in full at www.amertac.com/warranties.

AmerTac

250 Boulder Dr.

Breinigsville, PA 18031

610-336-1330

www.amertac.com

Made in China

INSTALLATION:

Adhesive Tape with Magnet:

1. Make sure the area where you want to attach the light is clean and clear of debris and dust.

2. With magnet in place, remove the protective sheet to expose the adhesive.

3. Locate the light in the position you want, and press rmly to ensure the adhesive sticks.

4. Now you can easily remove the light for battery changes as the magnet will stay in place.

CAUTION: Adhesive tape may remove paint or damage surface when removed.

Screws:

1. Remove mounting bracket from light.

2. For mounting position, leave adequate space for the light to slide

off the bracket.

3. Use the mounting bracket as a guide to drill two (2) pilot holes.

Secure mounting bracket to surface with screws (included).

Do not over tighten screws.

4. Attach light to mounting bracket.

LOCATION OF CONTROLS:

1. ON/OFF Tap Lens

2. Battery Compartment

OPERATING INSTRUCTIONS:

ON/OFF Tap Lens:

1. Press lens to turn light ON/OFF.

BATTERIES:

INSERTING / REPLACING THE BATTERIES

If the LEDs appear to be dim the batteries need to be replaced.

TO REPLACE THE BATTERIES

1. Remove battery compartment cover.

2. Remove old batteries (if replacing batteries).

3. Insert three (3) new “AAA” batteries (not included).

4. Make sure to follow the battery polarity guide when

installing new batteries.

5. Replace battery compartment cover.

LED COB BAR LIGHT OWNER’S MANUAL

ON/OFF Tap Lens

Side of Product

AAA Battery Locations

Back of Product – Battery Cover Removed

(Mounting Bracket)

Back of Product

Pilot Hole

Locations

Battery Compartment Cover

Summary of content (1 pages)

PAGE 1
LED COB BAR LIGHT OWNER’S MANUAL LOCATION OF CONTROLS: 1. ON/OFF Tap Lens 2. Battery Compartment INSTALLATION: Adhesive Tape with Magnet: 1. Make sure the area where you want to attach the light is clean and clear of debris and dust. 2. With magnet in place, remove the protective sheet to expose the adhesive. 3. Locate the light in the position you want, and press firmly to ensure the adhesive sticks. 4. Now you can easily remove the light for battery changes as the magnet will stay in place.