User Guide- DMX dimmer
d. LAN Setup
i. IP Address(Default DHCP Gateway): 10.10.100.254
ii. Subnet Mask: 255.255.255.0
iii. DHCP Type: Server
12. Next, select STA Interface Setting from the list of links on the left and ensure the following
settings are selected (See
Image04: STA Interface Setting
):
a. STA Interface Parameters
i. AP’s SSID: Westcott Dimmer
ii. MAC Address (Optional): [leave blank]
iii. Security Mode: WPA2PSK
iv. Encryption Type: AES
v. Pass Phrase: flexpanel
b. DHCP Mode
i. Hostname(Optional): HF-A21
13. Next, select Application Setting from the list of links on the left and ensure the following settings
are selected(See
Image05: Application Setting
)
:
a. Uart Setting
i. Baudrate: 230400
ii. Data Bits: 8
iii. Parity: None
iv. Stop: 1
v. CTSRTS: Disable
b. UART AutoFrame Setting
i. UART AutoFrame: Disable
c. Network Setting
i. Mode: Server
ii. Protocol: UDP
iii. Port: 6454
iv. Server Address: 10.10.100.255
v. MAX TCP Num. (1~32): 32
14. Finally, select Device Management link from the list on the left and ensure the following settings
are selected (See
Image06: Device Management
)
:
a. Administrator Settings
i. Account: admin
ii. Password: admin
b. Restart Module
i. Restart
15. Select Restart Module (See
Image07: Restart Module
. Any changes that have been selected in
previous sections require that the WiFi module be restarted.
)
16. The unit will restart and new settings are now applied. (See Image08: Rebooting
)
24