User Guide- DMX dimmer
DMX Operation: Addressing and Operation
Flex Mat Channel Requirements
● Daylight Mode – 1 channel
● Gel Mode – 1 channel
● Source Presets – 1 channel
● Bi-Color Mode – 2 channels
● RGBW+I Mode – 5 channels
Important DMX Addressing Information
● If more than one Flex Mat is set to the same DMX address, all Flex Mats addressed will function in
unison from the same signal. Individual light control is not possible.
● Individual Flex mat control can be achieved by assigning each mat to the appropriate number of
address values before adding the next mat.
● Hardline DMX controls will always take precedence over any other dimming control.
DMX (Hardwired) Connection
1. Locate the ON|OFF Power Switch located on the rear of the Cine DMX Dimmer. Turn the switch
to the ON position.
2. From the Main Menu, select DMX(001)(Local).
3. Set Correct DMX Channel from 001-512 (DMX Address default is 001)
4. ▲ (Up) and ▼ (Down) Arrows Change the Numbers (0-5, 0-9, 0-9)
5. ▶ (Right) and ◀ (Left) Arrows Control the Position
6. Connect the DMX512 5-pin cable into the DMX IN connector located on the side of the Cine DMX
Dimmer.
7. Utilize a DMX Control Board (sold separately) to control the Cine DMX Dimmer.
DMX over ArtNET Connection
1. Ensure that the WiFi Antenna, which can be located on the back of the dimmer, has been raised
to the ready position.
2. Once the preferred power supply is connected, locate the ON|OFF Power Switch located on the
rear top right of the DMX Dimmer. Turn the switch to the ON position.
18