User Guide- DMX dimmer
■ ▶ (Right) and ◀ (Left) Arrows control intensity (0-255)
■ Note: Daylight Mode does not allow users to save defined presets
Note: Menu items, order, and functionality may change with future firmware updates.
Source Presets, Gels & User Saved Presets
The Westcott Flex Cine Wireless DMX Dimmer arrives pre-loaded with over 100 predefined gels and
presets that are available when a Flex Cine RGBW mat is connected to the DMX Dimmer. Accessing,
tuning, adjusting and saving these presets is simple and easy.
Source Presets
The Wireless DMX Dimmer has been preloaded with 10 source presets* for use when a compatible Flex
Cine RGBW mat is attached. This mode is used to match environmental or non-Westcott light sources to
a designated Kelvin Temperature. These are based upon the most common types of light sources
utilized in architecture, industry and photo/film. These sources are as follows:
Accessing & Adjusting
1. From the main menu select the Mode menu option by pressing the center OK button.
2. Once in the Mode menu, press the ▲ (Up) and ▼ (Down) arrows to locate the Source Presets
option and press OK.
3. Press the ▲ (Up) and ▼ (Down) Arrows to locate the desired preset.
4. Once the desired preset is displayed on the screen use the ▶ (Right) and ◀ (Left) Arrows to control
the intensity.
5. To adjust the preset, PRESS and HOLD the ▼ (Down) arrow for 3 seconds to adjust the preset
settings.
6. Once the preset is fine-tuned, PRESS and HOLD the ▲ (Up) arrow for 3 seconds, or until the
screen reads Preset (Saved)
, to save the desired settings as a custom preset.
7. Return to previous menu screens by holding down the OK button.
*Note: The Source Presets
menu option is ONLY selectable when a compatible Flex Cine RGBW mat is
connected to the DMX Dimmer. If a Flex Cine RGBW mat is attached and the option is not selectable,
press the dimmer POWER SWITCH to the OFF position. Power the dimmer back on by pressing the
POWER SWITCH to the ON position.
15