LED MAT QUICK START GUIDE
Overview Metal Corners LEDs IP64 Rated Surface Touch Fastener Edging Grommets in Each Corner Dimmer TE-9 Pin Connector Magnets in Each Corner Flex Cine 1' x 1' RGBW Mat
Warning • • • • • • • • • Use only with a Westcott Flex Cine Dimmer Do not crease Do not sharply fold Keep away from fire or extreme temperatures Do not submerge in water Do not leave in wet conditions for extended amounts of time Do not get cable connector wet Avoid direct contact with any heat source or extreme cold Do not attempt to disassemble or repair LED chips IP 64 Rating Flex Cine Mats have an IP rating of 64, which is stated as being protected from total dust ingress and from water spraying from
Operation Connecting to a Flex Cine Dimmer 1. Ensure the dimmer is turned OFF. 2. Plug the Flex Cine mat’s TE-9 Pin connector into the TE-9 Pin receiver located on the top of the Flex Cine Dimmer. Proper connection may require the connector to be turned until the pins align and it easily inserts into the dimmer’s receiver. 3. Once connected, rotate the locking ring 3/4 clockwise on the cable connector to secure. 4. Connect the dimmer to a compatible power source.
Flex Cine Mounts & Modifiers Scrim Jim® Cine Frames Yokes Hard Diffusion Panels Barndoors Drum Softbox China Cubes Portable Softboxes Egg Crate Grids Learn more at FJWESTCOTT.
Lifetime Limited Warranty Westcott Flex Cine LED Mats have been manufactured under the highest standards of quality and workmanship. Westcott’s warranty obligations for this product are limited to the following terms. The F.J. Westcott Co.
