Quick Guide - Dimmer

Basic Operation
For the most up-to-date dimmer control operation, please visit
fjwestcott.com/7582 and scroll to the Support section for the
complete manual and video instruction guide.
1. After connecting a compatible Flex mat and power source to the
dimmer, locate the ON|OFF Power Switch located on the top of the
dimmer. Turn the switch to the ON position.
2. The dimmer screen will first indicate the connected V-Mount power
source type (when applicable), then the dimmer controls will appear
for the connected Flex mat.
3. Once the mat control screen is visible, the controls are as follows:
Flex Daylight 1' x 1' and 1' x 2' Mat Controls
• Use ◄ (Min) and ► (Max) to control light intensity (0-100%, ±1%
increments)
• The ▲ (Up), ▼ (Down), and OK buttons are disabled during daylight
control mode
Flex Bi-Color 1' x 1' and 1' x 2' Mat Controls
• Use ▲ (Up) and ▼ (Down) to move the → (Selection Arrow)
between BRT (Brightness) and CCT (Correlated Color Temperature).
• Once the desired control option has the → (Selection Arrow) located
next to it on the dimmer screen, use ◄ (Min) and ► (Max) to adjust
the Brightness (0-100%, ±1% increments) or CCT (2800-6000K,
±10K increments).
Flex Bi-Color Presets
The dimmer can store 4 user-defined presets for bi-color mats.
1. To access Preset Mode, press and hold OK.
2. Use ◄ (Min) and ► (Max) to select the desired preset.
3. To adjust the selected preset, use ▲ (Up) and ▼ (Down) buttons to
display and move the → (Selection Arrow) between BRT and CCT.
4. Then, use ◄ (Min) and ► (Max) to adjust the Brightness (00-100%,
±1% increments) or CCT (2800-6000K, ±10K increments).
5. Quickly press OK to save the desired settings to the selected preset.
6. Use ◄ (Min) and ► (Max) to select an additional preset to adjust or
to exit Preset Mode, press and hold OK.
Quick presses of the ◄ (Min) and ► (Max) buttons allow for slower
adjustments, while holding down the buttons allow for more rapid
changes.