Owner`s manual

Owner’s Manual
17
RJ45 MODULAR TEL. STYLE JUMPER DIAGRAMS
NOTE: To use these diagrams with these radios you
must plug the your RJ45 mic. in to the back “mic out”
jack of the RIGblaster. Using the supplied mic. cable,
screw the 8 pin plug in to the front of the RIGblaster and
plug the RJ45 end in to your radio’s RJ45 mic. jack. Be sure
to use the correct diagram for your brand radio, as follows,
and observe that PTT & MIC. jumper wires are crisscrossed!
Icom Modular RJ45 8 wire square
IC706 (all versions), FM Icoms (V8000, IC2000H, IC207H do
not work properly, see our support page).
Pin # Connection
1 Direct blue shunt jumper
2 PTT common (Ground)
3 Microphone audio, CRISSROSSED
4 MIC common (Ground)
5 Push to talk, PTT, CRISSCROSSED
6 Direct blue shunt jumper
7 Direct blue shunt jumper
8 Direct blue shunt jumper
Kenwood Modular RJ45 8 wire square
Pin # Connection
1 Direct blue shunt jumper
2 Direct blue shunt jumper
3 PTT common (Ground)
4 Push to talk, PTT, CRISSCROSSED
5 MIC common (Ground)
6 Microphone audio, CRISSROSSED
7 Direct blue shunt jumper
8 Direct blue shunt jumper
Yaesu Modular RJ45 8 wire square
RJ11 Yaesu radios, such as the FT100 need our 6 wire cable, not supplied.
Pin # Connection
1 Direct blue shunt jumper
2 PTT common (Ground)
3 Push to talk, PTT, CRISSCROSSED
4 Microphone audio, CRISSROSSED
5 MIC common (Ground)
6 Direct blue shunt jumper
7 Direct blue shunt jumper
8 Direct blue shunt jumper