Assembly Instruction

angled leg side table

assembly instructions

Page 1 of 35514997/5515002/7044209- 02.28.08

! Tools supplied:

! Do not throw away packaging materials until assembly is complete.

! Assemble this item on a soft surface, such as cardboard or carpet, to protect ﬁ nish.

! Proper assembly of this item requires 2 people.

Top 1x Leg 4x

Cross brace 2x

x4 tlob gnoLx61 tlob trohS

Spring washer 4x

Flat washer 4x

Parts

Hardware

PAGE 1
angled leg side table assembly instructions ! Tools supplied: ! Do not throw away packaging materials until assembly is complete. ! Assemble this item on a soft surface, such as cardboard or carpet, to protect ﬁnish. ! Proper assembly of this item requires 2 people. Parts A B Top 1x Leg 4x C Cross brace 2x Hardware D E Short bolt 16x F Long bolt 4x G Spring washer 4x 5514997/5515002/7044209- 02.28.
PAGE 2
angled leg side table assembly instructions 1. Align 4 legs (B) so that the points all come together in the center like the drawing shows. Place 1 cross brace (C) into routes in top section and 1 cross brace (C) into routes in bottom section. Insert 1 short bolt into each of the 16 holes in the cross braces. Tighten with supplied allen key. C Allen key D D C 5514997/5515002/7044209 - 02.28.
PAGE 3
angled leg side table assembly instructions 2. Lay top face down with the holes pointed upward. Next place assembled legs (B) with cross braces (C) onto top. Align holes from legs to top. Insert 1 long bolt (E) through 1 sping washer (F) and at washer (G). Insert this bolt assembly into hole in leg assembly as shown. Repeat for all four ip the table over. Allen key E F G CARE INSTRUCTIONS Hardware may loosen overtime. Periodically check that all connections are tight.