Assembly Instruction

2x2 daybed

assembly instructions

Page 1 of 510-14-09

! Tools required:

! Do not throw away packaging materials until assembly is complete.

! Assemble this item on a soft surface, such as cardboard or carpet, to protect finish.

! Proper assembly of this item requires 2 people.

x8 02 x 8m stlob trohsx7 08 x 8m stloB gnol

Hardware

spring washer m6 x 13 15x

flat washer m6 x 13 7x

barrel nut m6 x 13 7x

hex key 1x

PAGE 1
2x2 daybed assembly instructions ! Tools required: ! Do not throw away packaging materials until assembly is complete. ! Assemble this item on a soft surface, such as cardboard or carpet, to protect finish. ! Proper assembly of this item requires 2 people.
PAGE 2
x2 daybed assembly instructions 1. Align front rail and the back rail with the end frame as shown. Notice the hole in the back rail and its location. This rail must be installed like the drawing shows. Insert bolt (A), spring washer (C), at washer (D) thru the end frame. Insert barrel nut (E) into pre-drilled holes in the side rails. Tighten with supplied hex key (F). 2. Insert bolt (B), and spring washer (C) into metal brackets in the end of the side rails. Tighten with hex key (F).
PAGE 3
2x2 daybed assembly instructions 3. Repeat steps 1&2 to the other end of the bedframe.
PAGE 4
2x2 daybed assembly instructions 4. Position upper rail to end frame assembly and support rail as shown. Insert barrel nuts (E) into pre-drilled at washers (D) as shown. Tighten bolts using hex key (F). oors.
PAGE 5
2x2 daybed assembly instructions 6. Carefully lay slats into bedframe. CARE INSTRUCTIONS Hardware may loosen overtime. Periodically check that all connections are tight. nish, avoid the use of chemicals and household cleaners.