Manual

4 KS 90-1 / KS 92-1
4.4.3 Switching attitude non-linear ( CyCl= 2 )...............45
4.4.4 Heating and cooling with constant period ( CyCl= 3 )........46
4.5 Configuration examples ......................47
4.5.1 On-Off controller / Signaller (inverse) .................47
4.5.2 2-point controller (inverse) .......................48
4.5.3 3-point controller (relay & relay) ....................49
4.5.4 3-point stepping controller (relay & relay) ...............50
4.5.5 Continuous controller (inverse) .....................51
4.5.6 ∆ - Y - Off controller / 2-point controller with pre-contact ......52
4.5.7 Continuous controller with position controller .............53
4.5.8 Measured value output .........................54
5 Parameter setting level ......................55
5.1 Parameter survey ........................55
5.2 Parameters .............................56
5.3 Input scaling ............................59
5.3.1 Input Inp.1 and InP.3 .............60
5.3.2 Input InP.2...............................60
6 Calibration level .........................61
7 Special functions .........................64
7.1 DAC
®
– motor actuator monitoring ...............64
7.2 O
2
measurement ..........................66
7.2.1 Connection ...............................66
7.2.2 Configuration: ..............................67
7.3 Linearization ............................68
7.4 Loop alarm .............................69
7.5 Heating current input / heating current alarm ...........69
7.6 KS90-1 as Modbus master .....................70
7.7 Back-up controller (PROFIBUS) .................70
8 BlueControl ............................71
9 Versions ..............................72
10 Technical data ..........................73
11 Safety hints ............................77
11.1 Resetting to factory setting, ....................78