Instruction Manual

Programmer
9499-040-93811 / 59537-1 Page 70 of 88 Pro-16
Start by setting the bandwidth high and low (b.Lo; b.Hi) limits and the control output
reset value (
d.00) for the selected program. The bandwidth is valid for all.
g Configuration parameter pCom (r page 40) can be used for display suppression of
bandwidth parameters and control output reset value, which, however, remains
valid.
Select the segment number (SEg; Segm.-No) for the segment which is to be edited.
Now, enter segment type, segment end set-point, segment time/gradient and control
output.
After confirming parameter d.Out with key Ù , select the following segment.
Copying a program
The procedure for copying a program is shown below.
When confirming function COPY with key Ù, the program which shall be copied must
be selected (Src). Subsequently, the target program (dSt) must be adjusted. Press key
Ù to start copying.