Manual

Programmer parameter setting
8(16) programmers with 16 segments each are available to the user. The relevant
parameters must be determined in menu ProG .(
r page 57).
The procedure for editing a program is shown below.
Select the program you want to edit by means of keys
ID and confirm it with Ù.
Start by setting the bandwidth high and low (b.Lo; b.Hi) limits and the control
output reset value (d.00) for the selected program. The bandwidth is valid for all
segments (
r see chapter 7.3.6 ).
g
Configuration parameter pCom (r page 38) can be used for display suppression
of bandwidth parameters and control output reset value, which, however, remain
valid.
Select the segment number (SEg; Segm.-No) for the segment which is to be
edited. Now, enter segment type (
r page chapter ), segment end set-point,
segment time/gradient and control output.
After confirming parameter d.Out with key
Ù , select the following segment.
Copying a program
The procedure for copying a program is shown below.
When confirming function COPY with key
Ù, the program which shall be
copied must be selected (Src). Subsequently, the target program (dSt) must be
adjusted. Press key
Ù to start copying.
Programmer level
Programmer description 70 8840 profiler
ProG
1199
para
ÙÙÙ Ù
3 Sek.
1200
1199
Edit Prg
1199 1199
para para
Program Prog. 01
Ì
Ì
Ù
Ì
Ì
Ù
1199
para
SEG
Segm.-No
ÙÙ
1199 1199 1199
para para para
b.Lo
b.Hi
d.00
BandLow
BandHigh
0000
ÙÙÙÙÙ
1199 1199 1199 1199 1199
para para para para para
Time
SEG typE
SP
Pt d.Out
Segm.-No
Setpoint
Time 0000
Segm.-No + 1
ProG
1199
para
ÙÙ
ÙÙ
3 Sek.
1200
1199
Edit
Src dSt
1199
1199 1199
para
para para
Program
Ì
COpy
1199
para
Program