Owner's manual

1 INTRODUCTION
The
1
16
-DIN and
1
8
-DIN Plastics Controllers are economical, microprocessor-based
temperature controller specially designed for use in plastics applications. They
incorporate the latest in surface-mount and CMOS technology. The standard
features include:
• Dual four-digit LED display (upper display red, lower display green).
• Thermocouple or three-wire RTD sensor input
• Relay, SSR drive (10V) or solid state Output 1.
• Input range selected from the front panel.
• Heater current “ammeter” on front panel. Can use a unique two-wire
“SCRi” connection to dedicated silicon controlled rectifier stacks. Also
supports standard four-wire connection via a separate current
transformer.
• Heater Break alarms (high, low and short-circuit) to cater for most
requirements.
• Unique “Quick Transfer” for easy set up of heater break alarms. This can
be initiated from the front panel, digital input or via the communications
link
• Soft Start with dedicated setpoint, timer and Output 1 power limit.
• Adjustable alarm hysteresis.
• 90 - 264V AC power supply.
• Certified to EN50081-1:1992 and EN50081-2:1994 (Emission) and to
EN50082-1:1992 and EN50082-2:1995 (Immunity) EMC specifications.
Complies with EN61010-1:1993 Safety Standard.
• Front panel sealing to IP66 (NEMA 4) standard.
• CE rated (UL pending).
• Auto/Manual Control and Auto/Zero Power
• Pre-Tune and Self-Tune.
• Setpoint ramping.
O075-4 1-1
PM-0075