Owner's manual

2.10 MANUAL CONTROL MODE 2-5
2.11 HEATER CURRENT DISPLAY 2-5
2.12 SOFT START IN PROGRESS 2-6
2.13 QUICK TRANSFER OF HEATER CURRENT TO NOMINAL VALUE 2-6
2.14 PRE-TUNE 2-7
2.15 SELF-TUNE 2-7
2.16 TO VIEW THE HARDWARE DEFINITION CODE 2-8
3 SET UP MODE 3-1
3.1 ENTRY INTO SET UP MODE 3-1
3.2 SET UP MODE PARAMETERS 3-2
3.3 OPERATOR MODE DISPLAYS 3-17
3.4 TUNING THE CONTROLLER MANUALLY 3-18
3.5 SELF-TUNE 3-19
3.6 EXIT FROM SET UP MODE 3-20
4 MODBUS RTU COMMUNICATIONS 4-1
4.1 COMMUNICATIONS WRITE ENABLE/DISABLE 4-1
4.2 PHYSICAL REQUIREMENTS 4-1
4.3 MODBUS RTU PROTOCOL 4-1
4.4 INDIVIDUAL PARAMETERS 4-9
5 ASCII COMMUNICATIONS 5-1
5.1 COMMUNICATIONS WRITE ENABLE/DISABLE 5-1
5.2 PHYSICAL REQUIREMENTS 5-1
5.3 INDIVIDUAL PARAMETERS 5-7
5.4 ERROR RESPONSE 5-15
(iv ) O075-V1
PM-0075