User Manual

Er13 - RTD CAL5 Input 1. Check that resistance device is of the correct value

Error and properly connected to the instrument and is

within the tolerance limits as indicated in the CAL5

procedure of the Calibration section (page 49).

2. Turn off the power to the instrument and open the

cover. Loosen the platen hold down screw and swing

the platen open. Inspect the Processor board

(Appendix A-1, page 62) to insure that the input

conditioning jumpers are in the correct position for the

RTD input for the Terminal Board being calibrated.

For TB 4, JU4 should be in the non-volt position and

JU6 in the RTD position. For TB 5, JU5 should be in

the non-volt position and JU7 in the RTD position.

3. Perform the CAL5 procedure as described in the

Calibration section (page 49).

Er14 - Cold Junction 1. Perform the CAL3 procedure as described in the

Compensation Error Calibration section (page 48).

Er15 - Ground Reference 1. Perform the CAL2 procedure as described in the

Tolerance Error Calibration section (page 47).

Er16 - Program/ASEt Mode 1. Record all Program, Tune and Alarm Set mode

parameters. Checksum Error Perform CAL 1 procedure as described in the

Calibration section (page 47). Re-enter all

parameters.

Er17 - Calibration 1. Perform the calibration procedures that are

Checksum Error needed for the input sensors that will be used (page

46).

Er36 - Incorrect Crystal 1. Turn off the power to the instrument, wait 5 seconds,

For Digital Comm. then turn the power on.

Er37 - Incorrect Micro. 1. Turn off the power to the instrument wait 5 seconds,

For Digital Comm. then turn the power on.

Er38 - Incorrect RAM 1. Turn off the power to the instrument, wait 5 seconds,

for profiler then turn the power on.

2. Re-configure for non-profiler.

Momentary Er70 - 1. May occur when incrementing or decrementing a

Controller unable to respond value. Error clears itself.

within 250 milliseconds

Momentary Er71 - 1. Computer program must wait longer for a response

Byte received before the from the instrument.

response was transmitted