User Manual

23
RECORDER:
ALRM1 Red Rcdr - Lights when Alarm 1 is on.
Limit - Lights when Limit has been exceeded.
ALRM2 Red Lights when Alarm 2 is on.
C Red Lights to indicate that the process value is in terms of
degrees C (Celsius).
F Red Lights to indicate that the process value is in terms of
degrees F (Fahrenheit).
U Red Lights to indicate that the process value is in terms of
Engineering units.
- Red Lights to indicate a negative displayed value.
SP Green Indicates that the value displayed is the setpoint
(Limits only)
RECORDING CONTROLLER:
MAN Amber Lights when the Manual StbY mode is on.
OUT1 Red Lights when Output 1 is on or mADC output selected.
OUT 2 Amber Lights when Output 2 is on or mADC output selected..
ALRM Red Lights when either Alarm is on.
C Red Lights to indicate that the process value is in degrees C
(Celsius).
F Red Lights to indicate that the process value is in degrees F
(Fahrenheit).
U Red Lights to indicate that the process value is in terms of
Engineering units.
SP Green Indicates that the value displayed is the setpoint.
- Red Lights to indicate a negative displayed value.
Refer to Figure 1-2 (page 7) for the display features illustration.
3.5.2 KEYPAD CONTROLS
The keys on the keypad functions include:
SCROLL: Used to : 1. Display the enabled modes.
2. While in a mode, used to sequence the parameter codes and
values.
3. Exit some Test and Calibration functions
4. Work in conjunction with other keys:
a. With the UP key to display proportional output %
b. With the DOWN Key;
1) On power up to alter model #
2) Enter Cal/Test functions
UP: Used to: 1. Exit a mode.
2. Turn a mode On in the Enable mode
3. Increase a parameter numerical value
4. View the setpoint for Pen 1 (Press release)
5. Increase the setpoint value (Press hold)
6. Work in conjunction with other keys:
a. With the SCROLL key to display proportional output %
b. With the DOWN key;
1) Lamp test (Press release)
2) Enter the Enable mode (Press and hold for 11
seconds)
AUTO
MAN
AUTO
MAN