Owner manual
4
FIGURES & TABLES
Figure 1-1 Recorder Description 5
Figure 1-2 Recorder Display 7
Figure 2-1 Installation Panel Dimensions Conduit Opening Locations 9
Figure 2-2 Noise Suppression 11
Figure 2-3 Noise Suppression 11
Figure 2-4 Board and Terminal Locations 14
Figure 2-5 AC Power Input 15
Figure 2-6 Thermocouple Inputs 15
Figure 2-7 RTD Inputs 15
Figure 2-8 Milliamp, Volt and Millivolt Inputs 16
Figure 2-9 Remote Profile Run/Hold 16
Figure 2-10 Remote Setpoint Input VDC, mADC 17
Figure 2-11 Digital Communications 17
Figure 2-12A SPST Relay Output 18
Figure 2-12B SPDT Relay Output 18
Figure 2-13 SSR Output 19
Figure 2-14 Current Output 19
Figure 2-15 24 VDC Power Supply Option 20
Figure 2-16 Position Proportioning Control Output 20
Figure 3-1 Keypad Features 25
Figure 5-1 Changing Pens 50
Table 3-1 Program Mode Configuration Procedure 29
Table 3-2 Tune Mode Configuration Procedure 36
Table 3-3 Profile Entry Mode configuration Procedure 38
Table 3-4 Enable Mode Configuration Procedure 40
Table 4-1 Profile Continue Mode 44
Table 5-1 Calibration Procedure 52
Table 5-2 Test Procedures and Description 57
FLOW CHARTS
Flow - Calibration 51
Flow - Enable Mode 41
Flow - Program Mode 26
Flow - Test 56
Flow - Tune Mode 35