Owner manual

33
35 Relay B Assignment rLyb Same selection as rLyA 0
36 Relay C Assignment rLyC Same selection as rLyA 0
37 Relay D Assignment rLyd Same selection as rLyA 0
38 Relay E Assignment rLyE Same selection as rLyA 0
39 Relay F Assignment rLyF Same selection as rLyA 0
40 Relay G Assignment rLyg Same selection as rLyA 0
41 Relay H Assignment rLyH Same selection as rLyA 0
42 Current Output A CurA 0 to 6 0
Assignment 0=Not Assigned
1=Assigned to Process
Value Output-Pen 1
2=Assigned to Process
Value Output-Pen 2
3=Assigned to Output 1-Pen 1
4=Assigned to Output 2-Pen 1
5=Assigned to Output1-Pen 2
6=Assigned to Output 2-Pen 2
43 Current Output B Curb Same selection as CurA 0
Assignment
44 Current Output C CurC Same selection as CurA 0
Assignment
45 Current Output D Curd Same selection as CurA 0
Assignment
46 Current Output A CoAr 0 to 1 1
Range 0=0-20 mA
1=4-20 mA
47 Current Output B Cobr Same selection as CoAr 1
Range
48 Current Output C CoCr Same selection as CoAr 1
Range
49 Current Output D Codr Same selection as CoAr 1
Range
50 Profile Time Base Ptb 1=HHH.H Hours and Tenths 3
2=HH.MM Hours and Minutes
3=MM.SS Minutes and Seconds
51 Power Interupt Action PIA 0=Goes to Off mode 1
1=Continues Profile where
left off
2=Go into Hold where left off
3=Restart the Profile
52 Remote Run/Hold (optional) rrH 0=Not used 0
1=Remote overrides keypad
2=Remote or keypad will
cause hold
DISPLAY AVAILABLE FACTORY YOUR
STEP DESCRIPTION CODES SETTINGS SETTING SETTING