Owner's manual

13.1 Input and output allocation with pre-configured units
The signal (e.g. X1, Y1, alarms) allocation to the inputs and outputs for the relevant pre-configuration
(factory setting) is given in the following table. Allocation can be altered at any time via front panel
or interface and should be corrected before commissioning, if necessary.
Order numbers and functions for pre-configured units
9407-92(0;3;7)-xxx1x
Two-point controller (relay
output)
9407-92(1;4;8)-xxx1x
Two-point controller (logic
output)
9407-92(0;3;7)-xxx2x
Three-point stepping
controller
9407-92(1;4;8)-xxx2x
Three-point stepping
controller
9407-92(1;4;8)-xxx3x
Continuous controller
9407-92(1;4;8)-xxx4x
3<%-2>-point contr.
(‘heating’ = logic;
‘cooling’ = relay)
9407-92(3;7)-xxx5x
3-pnt. stepping controller;
3-element controller
9407-9X(4;8)-xxx6x
Continuous, 3-element
controller
Inputs
INP1 X1
INP3 - X2 - X2
INP4 - X3
INP5 X2; Wext; Wd Wext X2; Wext; Wd -
INP6 auxiliary variable ‘Z’ -
di1 W/Wext
di2 Auto/man
di3 Local / remote
di4 Programmer start / stop
di5 Programmer reset
di6 Program selection 1
di7 Program selection 2
di8 Selection parameter set 1
di9 Selection parameter set 2
di10 OVC+ (3-pnt. stepping)
di11 OVC- (3-pnt. stepping) w/dW
di12 Tracking
Outputs
OUT1 Y1 - Y1
OUT2 - - Y2 Y1 - Y2 -
OUT3 Xeff
OUT4 Alarm1 Y2 Alarm1
OUT5 Alarm2
do1 Programmer output 1
do2 Programmer output 2
do3 Programmer output 3
do4 Programmer output 4
do5 Auto/man
do6 W/Wext
Operating instruction KS94 44