Manual

4 KS 90-1 / KS 92-1
4.4.2 Switching attitude linear ( CyCl= 1 ).............45
4.4.3 Switching attitude non-linear ( CyCl= 2 ) ..........46
4.4.4 Heating and cooling with constant period ( CyCl= 3 )....47
4.5 Configuration examples ...................... 48
4.5.1 On-Off controller / Signaller (inverse) .............48
4.5.2 2-point controller (inverse) ...................49
4.5.3 3-point controller (relay & relay) ................50
4.5.4 3-point stepping controller (relay & relay) ...........51
4.5.5 Continuous controller (inverse) .................52
4.5.6 D - Y - Off controller / 2-point controller with pre-contact . 53
4.5.7 Continuous controller with position controller ........54
4.5.8 Measured value output .....................55
5 Parameter setting level ...................... 56
5.1 Parameter survey ....................... 56
5.2 Parameters ............................. 57
5.3 Input scaling ............................ 60
5.3.1 Input Inp.1 and InP.3 ...........60
5.3.2 Input InP.2 ..........................60
6 Calibration level ......................... 61
7 Special functions ......................... 64
7.1 DAC
®
– motor actuator monitoring ...............64
7.2 O
2
measurement .......................... 66
7.2.1 Connection ...........................66
7.2.2 Configuration:..........................67
7.3 Linearization............................ 68
7.4 Loop alarm............................. 69
7.5 Heating current input / heating current alarm ...........69
7.6 KS9x-1 as Modbus master..................... 70
7.7 Back-up controller (PROFIBUS) .................70
8 BlueControl ............................ 71
9 Versions .............................. 72
10 Technical data .......................... 74
11 Safety hints ............................ 78
11.1 Resetting to factory setting, .................... 80