User guide

Output variable
Output variable processing (function no.:4)
Code Des. R/W Type Description Range Rem.
30 Block R Block Block access (31, 35)
31 dYman R/W BCD Difference output variable -210..210
32 Yman R/W BCD Absolute output variable -105..105
33 Yinc R/W INT Increment. output variable 0, 1
34 Ydec R/W INT Decrement. output variable 0, 1
35 Ygrw_ls R/W INT Speed for incr./decr. output variable offset 0, 1
Tuning
Self-tuning(Function no.:5)
Code Des. R/W Type Description Range Rem.
00 Block R Block Block access (1, 3)
1 State_Tune1 R ST1 Status Tuning C
3 ParNeff R INT Eff. parameter set number 0...1
30 Block R Block Block access (31...39)
31 ParNr R/W INT Parameter set number effective 0 .. 1
32 Tu1 R BCD Delay time heating 0...9999 s
33 Vmax1 R BCD Rate of increase heating 0,000...9,999 %/s
34 Kp1 R BCD Process gain heating 0,000...9,999
35 MSG1 R INT Error code of self-tuning heating 0...8
36 Tu2 R BCD Delay time cooling 0...9999 s
37 Vmax2 R BCD Rate of increase cooling 0,000...9,999 %/s
38 Kp2 R BCD Process gain cooling 0,000...9,999
39 MSG2 R INT Error code of self-tuning cooling 0...8
Bem. C Status 1 Tuning ‘State_Tune1’
MSB LSB
D7 D6 D5 D4 D3 D2 D1 D0
Bit no. Name Allocation Status ‘0’ Status ‘1’
D0
OStab Process at rest no yes
D1
Orun Self-tuning mode off on
D2
Oerr Self-tuning result Ok error
D3...D5
‘0’ Always ‘0’
D6
‘1’ Always ‘1’
D7
Parity
Parameter a. configuration data
General
(Function no.: 0)
Code Des. R/W Type Description Range Rem.
B3 71 C100 R/W INT CFunc: controller function
CType: controller type
WFunc:set-point function
(T,H)
(Z)
(E)
0..xxyz
72 C101 R/W INT CMode:controller output action
CDiff: x/x-w differentiation
CFail: behaviour with sensor fail
CAnf: start-up circuit
(T)
(H)
(Z)
(E)
0..wxyz
73 C700 R/W INT OMode: self-tuning mode
OCond: process at rest
OGrp: allocation group self-tuning
OCntr: controlled adapt. mode
(T)
(H)
(Z)
(E)
0..wxyz
74 C180 R/W INT SWext: source for Wext (T) 0..x000
Function block protocol
25 9499 040 49411