User guide

Bem. A Unit_State1
MSB LSB
D7 D6 D5 D4 D3 D2 D1 D0
Bit no. Name Allocation Status ‘0’ Status ‘1’
D0
‘0’ Always ‘0’
D1
CNF Instrument status on-line configuration
D2...D4
‘0’ Always ‘0’
D5
UPD Parameter update no yes
D6
‘1’ Always ‘1’
D7
Parity
Bem. B DPErr
MSB LSB
D15 D14 D13 D12 D11 D10 D9 D8 D7 D6 D5 D4 D3 D2 D1 D0
Bit no. Name Allocation Status ‘0’ Status ‘1’
D0
Buszugriff nicht erfolgreich Kein Fehler Fehler
D1
Fehlerhaftes Prarametriertelegramm Kein Fehler Fehler
D2
Fehlerhafte Konfiguration Kein Fehler Fehler
D3
Kein Nutzdatenvberkehr mer Kein Fehler Fehler
D4...D15
‘0’ Always ‘0’
Bem. C HWbas
COM2 0 0
TH Z E
Basic version without COM2
00 0 0
COM2 with CANopen
01 0 0
COM2 with PROFIBUS-DP
10 0 0
COM2 with ISO1745
11 0 0
Example: Value ‘HWbas = 0100‘ means that the addressed instrument is a COM2 interface with CANopen
connection.
Bem. D SWopt
Version 0 0
TH Z E
Basic version
00 0 0
Water cooling (so far not available)
01 0 0
Bem. E SWCod
THZE
7th digit 8th digit 9the digit 10th digit
Example: Value ‘SWCod= 7239‘ means that the software for the addressed instrument contains code
number 4012 157 239xx.
Bem. F SWvers
THZE
0 0 11th digit 12th digit
Example: Value ‘SWVers= 11‘ means that the software of the addressed unit contains code number 4012
15x xxx11.
Bem. G UPD
Changing a parameter value or a configuration value via an interface is indicated in the UPD flag. This bit is
also set after mains recovery. The flag, which can be read also via code UPD, can be reset (value =0).
Function block protocol
15 9499 040 49411