Owner manual
.
12 Calibrating-level
In the calibration menu ( CAL) the measured value can be adjusted.
g
The measured value correction ( CAL) is accessible only, if ConF / InP/ Corr = 1 or 2 was
selected.
Two methods are available
•
Offset - correction
•
2-point - correction
g
The InL.x and InH.x values are presented with one digit. As reference for the correcting calculation the
full resolution is used.
g
Deleting the correction values is done fastest by switching off the measured value correction Corr = 0
or setting the scaling parameters to a linear behaviour.
+
The values InL.x and InH.x show the real measured value. The output values OuL.x and OuH.x start
with the preset value.
Calibrating-level
64 KS 45