Owner manual

Name
Description Cause Possible remedial action
AdA.H
Self-tuning heating
alarm
(ADAH)
See Self-tuning heating error
status
see Self-tuning heating error status
AdA.C
Self-tuning heating
alarm cooling
(ADAC)
See Self-tuning cooling error
status
see Self-tuning cooling error status
Lim.1
Latched limit value
alarm 1
Adjusted limit value 1 exceeded Check process
Lim.2
Latched limit value
alarm 2
Adjusted limit value 2 exceeded Check process
Lim.3
Latched limit value
alarm 3
Adjusted limit value 3 exceeded Check process
Inf.1
Time limit value
message
Preset number of operating
hours reached
Application-specific
Inf.2
Switching cycle
message
(digital outputs)
Preset number of switching cy
-
cles reached
Application-specific
g
Latched alarms Lim1/2/3 (E-element displayed) can be acknowledged, i.e. reset via digital alarm di1.
For Configuration, see page : ConF / LOGI / Err.r
g
When an alarm is still pending, i.e. unless the error cause was removed ( E display blinks), latched alarms
cannot be acknowledged and reset.
g
If sensor errors should not be on the error list any more after error correction without manual reset in the
error list, suppression via BlueControl
Ò
is possible by means of setting ILat.
CONF / othr / ILat 1 blocked
This setting is without effect on limit values Lim.1 … 3 configured for storage.
6.9.2 Error status self-tuning
Self-tuning heating ( ADA.H) and cooling ( ADA.C) error status:
Functions
KS 45 33 Maintenance manager / error list
Error-state Signification
2 Pending error Change to error status 1after error removal
1 Stored error Change to error status 0 after acknowledgement in error list 0
0 no error/message Not visible, except during acknowledgement