Owner manual

5 Operation

5.1 Front view

1 Line 1: process value display

2 Display 2: setpoint /output value/ unit-display / extended

operating level / errolist / values from Conf- and

PArA-level special functions as A-M, Func, run, AdA

3 operating mode “manual”

4 Error list (2 x ô ), e.g.

· Fbf. x sensor fault INP. X

· sht. x short circuit INP. X

· Pol. x wrong polarity INP. X

· Lim. x limit value alarm

· ...

5 Increment key

6 Enter key to select extended operating level or error list

7 Status indicator LEDs

· green: limit value 1 OK

· green blinking:no data exchange with bus coupler

(only on instruments with optional

system interface)

· red: limit value 1 active

· red blinking: instrument fault, configuration mistake

8 Display elements, active as bars

9 Status of switching output OUT1 active

0 Status of switching output OUT2 active

! Decrement key

§ PC connection for the BlueControl

engineering tool

In the first LCD-display line the measured value is shown. The second LCD-line normally shows the

setpoint. When changing over to the parameter setting, configuration or calibration level and at the

extended operating level, the parameter name and value are displayed alternately.

§ : To facilitate withdrawal of the PC connector from the instrument, please, press the cable left.

Operation

Front view 16 KS 45