User guide

39 KS40-1 burner
Index
0-9
2-point correction .............27
C
Calibration (CAL).............27
Calibration level (CAL)........27-29
Configuration with
QUIC ......14-17
Configuration without
QUIC .......18
Control inputs di1, di2, di3
Technical data ..............32
Current signal measuring range ......32
D
Digital inputs di1, di2, di3
Technical data ..............32
E
Error list ...................9
Example
3-point signaller .............16
3-point stepping controller .......17
Signaller with switch-over contact . . . 15
F
Front view ..................7
I
Input INP1
Parameters................25
Technical data ..............32
Input INP2
Parameters................25
Input scaling ................26
L
LED
Ada-LED................7
Err-LED.................7
ì -LED.................7
ò -LED.................7
run-LED.................7
SP.x-LED................7
M
Maintenance manager ............9
Manual tuning .............11-12
Mounting ..................5
O
Offset correction ..............27
Output OUT1
Technical data ..............33
Output OUT2
Technical data ..............33
P
Programmer
Changing segment end setpoint .....31
Changing segment time .........31
Parameter setting ............30
Set-up ..................30
Starting/Stopping ............30
Q
QUIC Codes ................14
R
Resetting to factory setting.........38
Resistance thermometer measuring range . 32
S
Safety hints ..............36-38
Safety switch ................5
Safety test .................34
Self-tuning
Cancelation .............10-11
Cancelation causes ...........11
Start ...................10
T
Thermocouple measuring range ......32
V
Voltage signal measuring range ......32