User guide

Function: 3-point signaller
Settings:
OUT1: Switch-on point is coupled with the set-point.
Switching difference Sd1: in units of phys. quantity.
OUT2: Switch-off point is always below the set-point!
Adjustment range d.SP : in units of phys. quantity
Switching difference Sd2: in units of phys. quantity.
Limit value OUT3: With the limit value exceeded, the relay is de-energized.
High limit value H.1: in units of phys. quantity.
Switching difference HYS.1: in units of phys.quantity.
Signal LEDs: LED1: lit, when OUT1 is energized
LED2: lit, when OUT2 is energized
OK LED: lit, when limit value not reached
Parameters: see chapter 5 “Parameter level”
Configuration level
KS40-1 burner 16 Configuration with qUIC
HYS.1
Limit OUT3
OUT2
-X
W
X
W
W
Sd1
Sd2
OUT1
ON
ON
OFF
ON
H.1
OFF
OFF
d.SP