Owner's manual

7 Calibration level
g
Measured value correction ( CAL) is only visible if ConF / InP.1 / Corr = 1
or 2 is chosen.
The measured value can be matched in the calibration menu ( CAL). Two me
-
thods are available:
7.1 Offset correction
( ConF/ InP.1 / Corr =1 ):
possible on-line at the process
2-point correction
( ConF/ InP.1 / Corr = 2 ):
w
is possible off-line with process
value simulator
w
online in 2 Schritten zunächst
den einen Wert korrigieren und
später, z.B. nach dem Aufheizen
des Ofens, den zweiten Wert
korrigieren.
Calibration level
Digital 280-1 Offset correction 37
X
standard-setting
Offset-correction
InL
OuL
new
display
OuLold
X
Standardeinstellung
2-Punkt-Korrektur
InL
InH
OuLneu
OuH neu
Display
OuH alt
OuLalt