Owner's manual

6.3 Input scaling
When using current or voltage signals as input variables for InP.1 or InP.2,
scaling of input and display values at parameter setting level is required. Specifi
-
cation of the input value for lower and higher scaling point is in the relevant elec
-
trical unit (mA / V).
6.3.1 Input Inp
g
Parameters InL.1 , OuL.1, InH.1 and OuH.1 are only visible if
ConF / InP.1 / Corr = 3 is chosen.
The parameters InL and InH determine the input range
Example mA:
InL= 4 and InH 0 20 means, the measurement is from 4 to 20 mA.
a
For using the predetermined scaling with thermocouple and resistance
thermometer (Pt100), the settings for InL.1 and OuL.1 and for InH.1 and
OuH.1 must have the same value.
Parameter setting level
36 Input scaling Digital 280-1
mA/V
phys.
unit
mA / V
phys. unit
OuH.x
OuL.x
InH.x
InL.x