Owner manual

Name Value range Description
Inf.2 Status message Inf.2 (number of switching cycles) (visible only with BlueControl!)
0 Not active
1 Active
Output Out.3 (analog)
Name Value range Description
O.tYP
Type of OUT3
0 Relay / logic (only visible with current/logic/voltage)
1 0 ... 20 mA continuous (only visible with current/logic/voltage)
2 4 ... 20 mA continuous (only visible with current/logic/voltage)
3 0...10 V continuous (only visible with current/logic/voltage)
4 2...10 V continuous (only visible with current/logic/voltage)
5 Transmitter supply (only visible with current/logic/voltage)
6 Frequency µ
O.Act
Direction of operation OUT3 (only visible with O.TYP=0 )
0 Direct / normally open
1 Inverse / normally closed
Lim.1
Signal limit 1 (only visible with O.TYP=0 )
0 Not active
1 Active
Lim.2
Signal limit 2 (only visible with O.TYP=0 )
0 Not active
1 Active
Lim.3
Signal limit 3 (only visible with O.TYP=0 )
0 Not active
1 Active
FAi.1
Signal INP1 fail (only visible with O.TYP=0 )
0 Not active
1 Active
FAi.2
Signal INP2 fail (only visible with O.TYP=0 ) µ
0 Not active
1 Active
FAi.F
Frequency error µ message
0 Not active
1 Active
Sb.Er
System bus error µ message
0 Not active
1 Active
Out.0
-1999
...9999
Lower scaling limit of the analog output (corresponds to 0% (0/4mA bzw. 0/2V, only
visible with O.TYP=1..4)).
Out.1
-1999
...9999
Upper scaling limit of the analog output (corresponds to 100% (20mA bzw. 10V,
only visible with O.TYP=1..4 )).
Out.L
-1999
...9999
Input value for min. output frequency (visible only with O.TYP=6)µ
FrQ.L
-1999
...9999
Min. output frequency in Hz (visible only with O.TYP=6)µ
Out.H
-1999
...9999
Input value for max. output frequency (visible only with O.TYP=6)µ
FrQ.H
0.0...9999 Max. output frequency in Hz (visible only with O.TYP=6)µ
Configuration level
42 Configurations UNIFLEX CI 45