Owner manual

Limit values Lim1 … Lim3
Name Value range Description
Fnc.1
(Fnc.2)
(Fnc.3)
Function of limit 1 (2, 3)
0 Switched off
1 Measured value monitoring
2 Measured value monitoring + alarm status latch. A stored limit value can
be reset via error list or a digital input ( -> LOGI/Err.r)
3 Signal change (in minutes).
4 Signal monitoring for rate of change (per minute) + storage of the alarm
status. A stored limit value can be reset via error list or a digital input (
->LOGI/Err.r)
Src.1
(Src.2)
(Src.3)
Source of limit 1 (2, 3)
0 Process value= displayed value
3 Measured value of the analog input INP1
4 Measured value of the analog input INP2
10 Counter/frequency measurement value
C.Std OFF; 1 … 9999999 Monitoring operating hour (only visible with BlueControl!)
C.Sch OFF; 1 … 9999999 Monitoring duty cycle (only visible with BlueControl!)
Outputs Out.1 and Out.2 µ (Relay)
Name Value range Description
O.Act
Direction of operation OUT1
0 Direct / normally open
1 Inverse / normally closed
Lim.1
Signal limit 1
0 Not active
1 Active
Lim.2
Signal limit 2
0 Not active
1 Active
Lim.3
Signal limit 3
0 Not active
1 Active
FAi.1
Signal INP1 fail
0 Not active
1 Active
FAi.2
Signal INP1 fail µ
0 Not active
1 Active
FAi.F
Frequency error µ message
0 Not active
1 Active
Sb.Er
System bus error µ message
0 Not active
1 Active
fOut Forcing of analog output OUT 1 (only visible with BlueControl!)
0 Not active
1 The value for this output is preset via interface
Inf.1 Status message Inf.1 (operating hours) (only visible with BlueControl!)
0 Not active
1 active
Configuration level
UNIFLEX CI 45 Configurations 41