Owner's manual

The current proportional output of SP3 shown as %.
Manual Power Off Off, 0 to 100, step 1
Manual power overrides PID calculated power output. The proportional output for SP3 will remain constant at the entered value. To return to
PID control set manual power to 0.
Display Alarm No No, Yes
When set to yes, alarm symbol is shown on controller image within CALogix-sw when an alarm output is switched.
Reset Latched Alarm No No, Yes
Used to clear a latched alarm output on SP3, once the alarm condition has cleared. Set value to yes to clear.
Module * - Programmer Default Options
Program number 0 1 to 31
Select programmer profile to run. See section on programmer
Run mode Off Hold, Run, Off
Program run mode. See section on programmer
Page 24 of 44