Owner's manual

Introduction
Installation
Mechanical Installation 4
a) Base-unit 4
b) Control module 4
c) Mounting 4
d) Removing a module 5
e) Removing the base-unit from DIN-rail 5
f) Cleaning 5
g) Dimensions 6
Electrical Installation 7
a) Output devices 7
b) Supply Voltage 7
c) Wiring a connector 7
d) Replacing modules 7
e) Inductive loads 7
f) EN61010 7
g) EMC guidelines 8
h) Supply and RS485 communications connections 9
i) Input options (module) 9
j) Output options (module) 9
k) Example circuit 10
l) Input sensor selection 10
Configuring CALogix 11
a) CALogix network 11
b) Multiple CALogix network 11
c) CALogix-sw minimum PC requirements 12
d) Installing CALogix-sw 12
e) Running CALogix-sw 12
f) Using CALogix-sw 13
Diagnostics 13
CALogix-sw configuration software 14
Starting CALogix-sw 14
Connecting to a controller 14
CALogix-sw toolbar 14
Base-unit setup 15
Configuring a PID module 16
a) Settings menu 16
b) Viewing Parameter settings 16
c) Changing a setting value 16
d) Initial settings 16
e) Park Mode 17
f) Setpoint adjustment 17
g) Autotune 17
h) Proportional cycle time 17
i) Second and third setpoints 18
j) Heat-Cool 18
k) Recalibration 19
l) Linear inputs 19
Page 2 of 44