Owner's manual

Open File
Open controller application settings or logic program file.
Note : when a saved application or logic file is loaded to a CALogix unit, the logic program will not be running.
Save
Save controller application settings or logic programs.
Export Application
Creates rich text file (.rtf) with application settings data
Export device
Creates rich text file (.rtf) with current device settings data
Export program (only available when programmer interface is open)
Creates rich text file (.rtf) with device program data
Export logic (only available when logic desktop is open)
Creates rich text file (.rtf) with logic program data
Properties
Select security settings, see section on security settings
Edit programs
Open programmer interface for profile creation, see section on programmer
Edit logic
Open logic desktop, see section on logic programming
About
BASE UNIT SETUP
To access settings for a base unit
1. Right-click on controller image.
2. Mouse over properties, then left-click on base-unit, see diagram above.
3. Double-click on (+) to expand menus.
4. Base-unit settings are shown as below.
Base-unit Configuration Default Options
Baud rate 9600 2400, 4800, 9600, 19200, 38400, 57600, 115200. (read only)
The network baud rate can be read. CALogix baud rate is automatically set on power-up to match the baud rate used by the Modbus
master.
Modbus address 1 1 to 255, step 1
The base-unit Modbus address can be set to a value of 1 to 255. A maximum of 31 base-units can be connected in a network.
Base-unit diagnostics Default
Serial number Preset (read only)
The CALogix serial number is factory set before shipment
Firmware version Preset (read only)
Note : If the Modbus address is changed CALogix-sw will loose communications with the base-unit as it is still
communicating using the original address. If the address is changed, exit CALogix-sw and browse for the controller using
the new address.
Page 15 of 44