Manual

1
/
4
-DIN,
1
/
8
-DIN &
1
/
16
- DIN Controllers & Indicators - Product Manual
59305, Issue 7 – March 2014 P6170, P8170 & P4170 Model Group Page 71
Parameter
Lower
Display
Upper
Display
Description
Default
Value
When
Visible
Remote
Auxiliary Input
Range


0 to 20mA DC input

(or  if
 =
) 
 or
=


4 to 20mA DC input

0 to 10V DC input

2 to 10V DC input

0 to 5V DC input

1 to 5V DC input

0 to 100mV DC input
=


Potentiometer (2K
Remote
Setpoint Upper
Limit

 to 
RSP value to be used when RSP input is
at maximum.
Range
max
 or
 =

Remote
Setpoint Lower
Limit

 to 
RSP value to be used when RSP input is
at minimum.
Range min
 or
 =

Remote
Setpoint Offset

Offset applied to RSP value. Constrained
within Scale Range Upper Limit and
Scale Range Lower Limit.

 or
 =

Configura-
tion Mode Lock
Code

 

Always
*Note:
Alarm parameters marked * are repeated in Setup Mode.
**Note:
This controller uses Three-Point Stepping control. This requires two identical outputs (2
Relays, 2 Triacs, 2 SSR Drivers or 1 Dual Relay) to be configured for the  (Valve
Open) &  (Valve Close) functions.
***Note:
If  or  =  the remote setpoint input feature is disabled. The instrument
uses the two internal setpoints (SP1 & SP2) instead.
If  and  are set to the same value, the status of digital input 2 will take
precedence over digital input 1.
 cannot be set for Remote/Local Setpoint Selection if ( ) if Auxiliary Input B is
used for Valve Position Indication.