User`s manual

MAINTENANCE AND TROUBLESHOOTING

Inspectand tighten all parts of the exercise cycle reg-

ularly.Replace any worn parts immediately.

To clean the exercise cycle, use a damp cloth and a

small amount of milddetergent. Important: To avoid

damage to the console, keep liquids away from

the console and keep the console out of direct

sunlight.

BATTERY REPLACEMENT

Ifthe console display becomes dim, the batteries

should be replaced; mostconsole problemsare the

resultof low batteries. To replace the batteries, refer

to step 4 on page 5 and remove the consolefrom the

handlebar. Next, refer to step 3 on page 5 and insert

three batteries into the console. Reattach the console

to the handlebar,being careful notto pinchthe wires.

HOW TO ADJUST THE REED SWITCH

Ifthe console does not display correct feedback, the

reed switch shouldbe adjusted. In order to adjustthe

reed switch, the left side shield mustbe removed.

Using an adjustable wrench, turn the Left Pedal (24)

clockwiseand remove it. Next, remove the five M4 x

25mm Screws (41) and the M4 x 16mm Round Head

Screw (3) from the Left Side Shield (17). Carefully

remove the Left Side Shield.

Next, turn the resistance knob to the lowest setting

Withthe left side shield removed, locate the Reed

Switch (43). Turn the Crank (21) untilthe Magnet (38)

is alignedwith the Reed Switch. Loosen, but do not

remove, the M4 x 16mm Screw (49). Slide the Reed

Switch slightlycloserto or away from the Magnet.

Retightenthe Screw. Turn the Crank for a moment.

Repeat untilthe console displayscorrectfeedback.

When the Reed Switch iscorrectlyadjusted, reattach

the left side shield and the left pedal.