User Manual

9
EN
ACCESSORIES
Allen key 1
Charger (WS9924U) 1
Battery pack (WS9970) 1
Dust adapter 1
10pcs blade box 1
21TPI BIM Metal cutting blade 2
8TPI HSS Aluminum cutting blade 2
#50 65Mn Ceramics blade 2
10TPI HCS Wood cutting smooth blade 2
6TPI 65Mn Wood cutting scroll blade 2
We recommend that you purchase your accessories listed
in the above list from the same store that sold you the tool.
Refer to the accessory packaging for further details. Store
personnel can assist you and offer advice.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
INTENDED USE
The machine is intended for sawing wood, plastic, metal
and building materials while resting firmly on the workpiece.
It is suitable for straight and curved cuts with bevel
angles to 45°. The saw blade recommendations are to be
observed.
Before assembling or performing maintenance always
disconnect power from the tool by removing the battery.
BEFORE PUTTING INTO OPERATION
1. CHARGING INSTRUCTIONS
WARNING: The charger and battery pack are
specially designed to work together so do not
attempt to use any other devices. Never insert or allow
metallic objects into your charger or battery pack
connections because of an electrical failure and hazard will
occur.
NOTE:
a) Do not use any charger other than that specifically
provided for use with the equipment.
b) If the battery pack is very hot you must remove your
battery pack from the charger and allow time for the battery
to cool down before recharging.
c) The battery in your new tool is not charged when it leaves
the plant. Therefore it must be full charged before using the
first time
d) Please charge the battery to reach full or no less than half
charge before storage. If the tool will not be used for long
periods of time, charge the battery every 3-6 months.
CHARGING PROCEDURE (See Fig. A)
Connect the battery charger to the power supply and the
indicator light should turn green.
Slide the charger base on the battery pack make
connections and the indicator light will turn red to show that
the charging has started.
When charging is completed, the light will turn green. The
pack is now fully charged, unplug the charger and remove
the battery pack.
WARNING: When battery charge runs out after
continuous use or exposure to direct sunlight or
heat, allow time for the tool to cool down before re-charging
to achieve the full charge.
Light Status
Red on
Charging
Green on
Fully Charged
OPERATION
1. INSTALLING AND REMOVING THE BATTERY PACK
a) TO REMOVE THE BATTERY PACK (See Fig. B1)
Depress the Battery Pack Release Button firmly first and
then slide the Battery Pack out from your tool.
b) TO INSTALL THE BATTERY PACK (See Fig. B2)
Slide the fully charged Battery Pack onto the tool with
sufficient force until it clicks into position.
1. ON / OFF SWITCH
Depress on/off switch (3) to start and release it to stop your
tool (See Fig. C).
2. SWITCH LOCK-ON BUTTON
Depress on/off switch then lock-on button, release on/off
switch first then lock-on button second. Your switch is now
locked on for continuous use. To switch off your tool just
depress and release on/off switch (See Fig. C).
3. HAND GRIP AREAS
Always ensure you maintain a firm grip whilst operating
your jigsaw.
4. ALLEN KEY STORAGE (SEE FIG. C)
The allen key is placed at the position as shown.
5.BLADE FITTING
NOTE: Remove the plug from the socket
before carrying out any adjustment, servicing or
maintenance. Wear protective gloves when assembling the