User manual

WESAUDIO

4/9/18

_HYPERION USER MANUAL REV1

2. Installation and compatibility.

WesAudio _HYPERION equalizer module is designed to be installed into:

 An API™ 500 Series compatible rack

 _TITAN or any other ng500 compatible chassis,

WesAudio _ HYPERION cannot function standalone, requiring the power source supplied by the rack

system.

Two important NOTES:

 Unit needs to warm up for about 5 minutes before usage as its temperature may

affect some internal variables – like frequencies of each band, and very slightly gain

and Q settings.

 Unit produces fair amount of heat because of its power consumption, it is highly

recommended to leave empty space above and below chassis to allow proper air

circulation. Ideally 1U space above, and 1U space below.

After unpacking your _HYPERION module, please check for any visible damage that may have occurred

during transit. If there is any problem, please contact your dealer immediately!

Module installation walkthrough:

Choose the position in the rack to which you will install the module and slide it in so that the edge

connector of the module aligns with the matching connector in the rack. A gentle push and the module

should slide home into the rack connector. Attach the front panel to the front of the rack with screws

supplied by your rack manufacturer. This is important for mechanical rigidity. Do not over tighten these

screws to avoid stripping out the threads. Apply power, test that everything is working OK, and most

importantly, enjoy!

!!!Ensure the rack is completely powered down before attempting

installation to prevent damage to the module!!!