User manual

WESAUDIO
4/9/18
_HYPERION USER MANUAL REV1
33
9.4.2.1. Synchronized memory enabled
This is default setting enabled through “Plugin and Hardware memory sync” option, and it
causes direct link between unit and plugin memory. In this case, when plugin is connected with a
hardware, all parameters including number of fast presets which unit can store (e.g. A/B) will be
synchronized. So when plugin will be disconnected (through manual toggle button hit, DAW session
close, etc.) all hardware configuration will remain unchanged.
9.4.2.2. Synchronized memory disabled
In this case, plugin works as separate form of persistence implementation. That means if HW
unit is connected to work with the Plugin, all settings from Plugin are applied to the device (or from the
hardware to the plugin), however unit configuration will get back to previous state when Plugin will
initiate disconnection (through connection toggle button, session close etc.) . So in practice HW unit
internal memory isn’t affected by the software at all. This functionality can be useful if user needs to
switch often between different modes, for example session needs to be recalled, but unit is used during
production activities without any session loaded (then unit can be easily recalled through session load,
and when session is closed, unit will go back to the state before the recall had happened).