User manual

WESAUDIO
4/9/18
_HYPERION USER MANUAL REV1
18
7. Unit modes
_HYPERION is an equalizer which can work in following modes:
 DUAL MONO – each channel works as independent units – channels are unlinked.
 STEREO – channels are linked together which allows processing stereo audio signal in convenient
way.
 MID-SIDE – signal on the way in is encoded into MID and SIDE signal, and at the end of the circuit it is
decoded back to stereo. This allows separate control over MID and SIDE channels respectively.
Regardless above modes, _HYPERION can be used in following ways:
 STANDALONE – unit is not connected through USB or _TITAN chassis with digital plug-in or any other
control application, it is used as any normal analog unit.
 CONNECTED to a PLUGIN – where unit is connected to a plugin which allows total recall and remote
control.
7.1. Unit standalone usage
Standalone usage means that unit isn’t connected anyhow to management client – e.g.
AAX/VST/VST3/AU plug-in or any standalone application. It is used as standard analog unit using a front
panel. In this mode when channels are unlinked (please see table below), front panel buttons LEFT/MID and
RIGHT/SIDE can be used to select particular channel:
Below table describes unit behavior:
Mode
Management - A/B and Bypass
Channels
Dual mono
Global mode (1)
Unlinked mode (2)
Stereo
Global mode (1)
HW Linked mode (3)
Mid-Side
Global mode (1)
Unlinked mode (2)