User manual

WESAUDIO
4/9/18
_HYPERION USER MANUAL REV1
11
8) LMF Frequency – low-mid filter frequency control.
9) LMF Gain – low-mid filter gain control.
10) HPF Frequency – high pass filter frequency control.
11) LF Frequency – low filter frequency control.
12) LF Gain – low filter gain control.
13) LEFT/MID channel button – hitting this button shows LEFT/MID channel on a front panel.
14) RIGHT/SIDE channel button – hitting this button shows RIGHT/SIDE channel on a front panel.
15) A – fast preset change – enables preset “A”.
16) DUO – enables dual mono mode.
17) THD – toggles THD level, possible steps – OFF (LEDs disabled), MED, HIGH.
18) Bypass – bypass switch.
19) B – fast preset change – enables preset “B”.
20) MS – enables mid-side mode.
21) STR – enables stereo mode.
22) GAIN mode – sets unit gain mode which affects all bands gain controls, and output controls.
Possible steps:
a. 15dB for cut and boost, with 0.25 dB change on each step,
b. 5dB for cut and boost, with 0.083 dB change on each step.
23) HL1 - indicates state of channel LEFT/MID connection to HOST – this led will be enabled if plug-in
is connected to this particular channel.
24) DATA - indicates that data is being sent from DAW to device.
25) HL2 - indicates state of channel RIGHT/SIDE connection to HOST – this led will be enabled if plug-
in is connected to this particular channel.
26) SOFT – this button enables 6dB per octave HPF mode.
27) LF BELL – indicates low filter mode, if enabled, bell mode is active, if disabled, shelf. To toggle
between modes LF frequency encoder has to be pressed (pushed).
28) HF BELL – indicates high filter mode, if enabled, bell mode is active, if disabled, shelf. To toggle
between modes HF frequency encoder has to be pressed (pushed).
29) Band bypass LEDs – each band can be independently bypassed, these LEDs indicates if particular
band is active. If LED is active, band is also active. To toggle from on to off, band gain encoder has
to be pressed (pushed).
30) USB socket - module control USB port.