!!!! 300 LOAD CAPACITY Combined Weight of User and Materials Type IA Duty Rating TELESCOPING MULTILADDER PROFESSIONAL GRADE Telescoping design for maximum versatility Operating Procedure and Safety Instructions Model MT-22 WERNER CO., 93 WERNER ROAD, GREENVILLE, PA 16125-9499 Phone: (724) 588-8600 www.wernerladder.com P/N62320-01 ©2003 Werner Co.
TELESCOPING MULTILADDER PROFESSIONAL GRADE Telescoping design for maximum versatility Operating Procedure and Safety Instructions WARNING: 1. Read these instructions completely before using the ladder. If you don’t understand call 724-588-8600 for assistance. 2. Failure to comply with all instructions may result in serious injury. 1 DESCRIPTION • Product overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 • Terminology . . . . . . . . . . . . . . . . . . . . . . . . . .
1 DESCRIPTION PRODUCT OVERVIEW WORKING HEIGHTS The Werner MT Series Telescoping Multiladder is a professional grade, multi-purpose ladder that can be changed into different positions and working heights. The MT Series ladders consist of three sections and two different locking mechanisms. (See Positions 1–4) WARNING The following chart shows the working heights of each of the available units in each of the 4 main positions.
2 SAFETY INSPECTION OF PRODUCT For safety, follow these inspection instructions: WARNING Failure to follow these instructions could result in serious injury or death. Always follow these safety instructions. • Never use ladder with missing, worn or damaged parts. Inspect before each use. • Never repair a damaged ladder without permission from Werner Co. • Destroy ladder if exposed to excessive heat (such as in a house fire) or corrosive agents (like acids or alkalis).
3 4 SOFT TOUCH PUSH KNOB LOCKING HINGE SPRING LOADED “J” LOCKS HINGE OPERATION LOCK OPERATION For safety, follow these Soft Touch push knob hinge instructions: For safety, follow these Spring Loaded “J” Locks instructions: The MT Series ladders outer sections allow the ladder to telescope and change heights in all the configurations, besides the scaffold mode. Each of these configurations is made possible using the 4 Spring Loaded “J” locks 2 each on either side.
5 Position #2 PROPER USE HOW TO SETUP POSITIONS The Werner MT Series Telescoping Multiladder can be used in positions shown below with no additional equipment required. The following instruction will demonstrate how to change the Werner Telescoping Multiladder. Stairway Stepladder Position #1 Twin Stepladder 1) To configure the MT Series ladder into the stepladder position, follow the directions for changing the angle of the ladder (Section 3) using the push knob locking hinge.
5 PROPER USE Position #4 HOW TO SETUP POSITIONS (continued) Position #3 Extension Ladder 75° 2-Scaffold Base 1) Configuring the MT Series ladder into the 2-Scaffold Base position requires the use of the dynamic hinge kit that is included with your MT Series ladder. 2) Separate the inner and outer sections completely by unlocking the “J” locks and sliding the outer sections off the inner section.
NOTES
