Product Manual

SOFT ANCHORAGE CONNECTOR
USER INSTRUCTIONS
Page 11
ENGLISH
f. Pour-In Anchor Straps
Pour-in-place anchors are actually simplied standard web chokers
that have been modied to continue functioning as an anchorage
connector after being partially embedded in concrete. As such they
conform to most of the same instructions and warnings contained
in the previous Cross arm strap/ webbing choker section. All Werner
Pour-In anchors are for one-time use only.
Installing a Pour-In Anchor Strap
1. Select a location with required anchorage strength and
unobstructed fall clearance. Either place the strap’s loop end
over the rebar or use the
loop to “choke” it. To choke
it, loop strap around
the re-bar and pull the
exposed end (with loop
or D-ring) through the end
loop. Tighten the choke
on the rebar. Position the
exposed end with the
other loop or D-ring at
least six inches outside
the form. Secure the strap
so that it can not be pulled
inside when the concrete
is poured. Position the
strap’s wear protector so
it will be partly embedded
in the poured concrete
and partly exposed. It’s
important that the wear
protector is positioned
to protect the main load-
bearing webbing from
contact with the sharp
edge of the poured
concrete.
Anchorage Connector Installed
4” min
Poured
Concrete
Floor
Steel
Re-bar
Shear
Wall
Concrete
Column
Imbedded Concrete
Anchor Strap
Installing on Completed Cage
Anchorage Connector Installed
Web Cut
Line
Steel
Re-bar
Concrete
Column