Specification

Page 5
ENGLISH
1. Check the webbing for cuts, abrasion, burns, welding spatter,
or discoloration that could be caused by chemical exposure.
The WebAlert feature of the webbing on some models is
intended to make these much easier to spot. If any abnormality
is noted check further by bending the webbing to expose the
irregularity to determine severity.
2. For cable legs, examine the entire length for any breaks and
the swaged ttings for any irregularities.
3. Check all stitching for any broken threads.
4. Check all hardware for cracks, bends, irregularities, corrosion,
or sharp edges. Check the snap hook gates for proper smooth
operation. The engagement release for the hook’s gate is
visible for inspectability. Ensure the mechanism is undamaged
and functioning correctly.
5. Check all plastic parts for damage or cracks. If any
abnormalities are found, the product should be removed from
service.
6. Verify that all labels are in place and legible. Examples of
the labels can be found in section IV of these instructions.
If abnormalities are found in any of these areas then the
competent person should be consulted to determine if that item
is safe for continued use or if it should be removed from service.
Warning:
No alteration or modication of any fall protection equipment
is permitted for any reason unless authorized in writing by Werner Co.
LOCKED UNLOCKED LOCKED UNLOCKED
LOCKED UNLOCKEDTWIST