User`s guide

89
CHAPTER 6 - DETAILED PARAMETER DESCRIPTION
Figure 6.3
- Block diagram of the local and remote operation mode
LOCAL
Frequency
Reference
P221
Controls
P229
(stop/run,
FWD/REV
andJOG)
0
Keypad
(HMI-CFW08-P,
HMI
-CFW08-RPand
HMI-CFW08-RS)
1
AI1
2
or 3 AI2
4
EP
5
Serial
6
Multispeed
7
Add AI
8
Add AI > 0
0
Keypad (HMI-
CFW08-P and HMI-
CFW08-RP)
1
Terminals
XC1 (DIs)
2
Serial or HMI-
CFW08-RS keypad
REMOTE
Frequency
Reference
P222
Controls
P230
(stop/run,
FWD/REV
andJOG)
F* REFERENCE
COMMANDS
Local/Remote Selection (P220)
+
Local/RemoteCommand
( , DI, Serial, etc)
6.3
PARAMETER
LISTING
Inorder to simplifytheexplanation, the parameters havebeen
grouped by characteristics and functions:
Variables that can be viewed on the
display, but can not be changed by the
user
Programmable values used by the
CFW-08 functions
They define the inverter characteristics,
the functions to be executed, as well as
the input/output functions of the control
board
Data about the applied motor: data
indicated on the motor nameplate and
those obtained during the running of the
self-tuning routine
Here are included parameters related to
special functions
0
Keypad
(HMI
-CFW08-P,
HMI- CFW08- RP and
HMI-
CFW08-RS)
1
AI1
2
or 3 AI2
4
EP
5
Serial
6
Multispeed
7
Add AI
8
AddAI>0
0
Keypad
(HMI-CFW-08-P and
HMI - CFW-08-RP)
1
Terminals
XC1 (DIs)
2
Serial or HMI-
CFW08-RS keypad
Read-only Parameters
Regulation Parameters
Configuration Parameters
Motor Parameters
Special Function Parameters