User`s guide

Summary
3.3.2 Emission and Immunity Levels Description
........
52
3.3.3 Inverter Models and Filters
..................................
54
3.3.4 EMC Filters Characteristics
...............................
57
CHAPTER 4
Keypad (HMI) Operation
4.1 Keypad (HMI) Description
.........................................
67
4.2 Use of the Keypad (HMI)
...........................................
68
4.2.1 Keypad Operation
..............................................
69
4.2.2 Inverter Status
.....................................................
70
4.2.3 Read-Only Parameters
.......................................
71
4.2.4 Parameter Viewing and Programming
...............
71
CHAPTER 5
Start-up
5.1 Pre-Power Checks
....................................................
74
5.2 Initial Power-up
..........................................................
74
5.3 Start-up
......................................................................
75
5.3.1
Start-up Operation via Keypad (HMI) -
Type of Control: Linear V/F (P202 = 0)
...............
76
5.3.2
Start-up Operation via Terminals -
Control Mode: Linear V/F (P202 = 0)
.................
77
5.3.3
Start-up Operation via Keypad -
Control Mode: Vector (P202 = 2)
........................
78
CHAPTER 6
Detailed Parameter Description
6.1 Symbols ...
.................................................................
83
6.2 Introduction
................................................................
83
6.2.1 Control Modes (V/F and Vector)
.........................
83
6.2.2 V/F Control
.........................................................
83
6.2.3 Vector Control (VVC)
..........................................
84
6.2.4 Frequency Reference Sources
...........................
85
6.2.5
Commands
.........................................................
88
6.2.6 Local/Remote Operation Modes
........................
88
6.3 Parameter Listing
......................................................
89
6.3.1
Access and Read-only Parameters -
P000 to P099
.....................................................
90
6.3.2 Regulation Parameters - P100 to P199
.............
92
6.3.3 Configuration Parameters - P200 to P398
.......
102
6.3.4 Motor Parameters - P399 to P499
...................
128
6.3.5 Special Function Parameters - P500 to P599
..
131
6.3.5.1 Introduction
..............................................
131
6.3.5.2 Description
..............................................
131
6.3.5.3 PID Start-up Guide
...................................
134