User`s guide

159
CHAPTER 8 - CFW-08 OPTIONS AND ACCESSORIES
The following figure shows some possibilities for connecting
this module in a RS-485 network. Usually, theconnection a)is
applied,but connectionsb) and c) canalso be used according
to the situation.
Notice that terminal indicated by the symbol
shall be
connected to the ground.
Figure 8.18 a) to c)
- Connection possibilities for the KRS-485-CFW08 module
CANopen Communication Module and Keypad:
This optional module, with a CANopen interface (plug-in
connector) anda keypad, is installed in the front of the drive in
the place of the standard parallel keypad (HMI-CFW08-P).
For instruction on how inserting and removing this module,
refer to the installation instruction for the KCS-CFW08 in this
manual.
The functions of each pin are indicated in the silk screening
above the communication connector.
It is possible to command, setup and monitor the CFW-08
through this communication interface. Inthis case, themaster
can be a PLC, the CFW-09 with a PLC board, etc.
This module can be purchased along with the inverter just by
includingthe code“A3”in the control board field of the product
part number, such as, CFW080040S2024PO
A3
Z (refer to
item 2.4 of this manual for further information on how ordering
the product).
8.14
KFB-CO-CFW08
Figure 8.19
-
Dimensions in mm [in] of the CANopen communication module
KFB-CO-CFW08
a)
b)
c)
3
6
.
8
[
1
.
4
5
]
CFW-08
Master
A
B
A
B
A
B
A
B
CFW-08
Master
COM
COM
COM
COM
XC12
XC12
Earth
Earth
CFW-08
Master
A
B
A
B
COM
XC12
Earth
COM
42.6
[1.68]
11
[0.43]
57
[2.24]
20
[0.79]
5.9
[0.23]